Since the controlling via the Mainboard with PWM fans is much cheaper than using a fan controller, this cable is to positively. In order to increase the low number of motherboard slots for this type of fans this cable be used. Alternatively, the 4 pin Molex to Storm supply of the two PWM fans are used.
The adapter is delivered in a plain black. The cables are shielded with a matching sheath of Flexsleeves. It provides additional protection against abrasion. This Increases lifespan of the cable. The end towards the connectors are provided with heat-shrinkable tubing, so that a clean finish.
This cable is not only practical, but also optically appealing. The surrounding mesh, what the actual cable sleeve is extremely dense and offers the effect for which all pro: A completely new, in order to better emphasize the uniqueness of the system! Particular attention was (the sleeve), the plug and heatshrink placed on the combination of the cable sheathing to create a matching design.
Phobya's goal is to provide a piece to get the professional and hobby Case modders here far opposed. Sleeving is a lot of work and requires a lot of time, so now can be redesigned with these cables by Phobya the whole system just as you would like it, just by simply adding these cables.
• 2x 4 PIN PWM female connector
• 1x 4-Pin Molex connector
• Colour: Black sleeve, black connectors, black heatshrink
• Dimensions: 50cm fully
• RoHS compliant
• 1x Phobya Y-cable for PWM splitter 4Pin PWM to 4Pin PWM & 4-Pin Molex 50cm - black
No posts found