10MM (3/8 ID - 1/2 OD) Screw fitting 90 degrees - G1 / 4 Black Nickel
90 degree angle Screw fitting for 3/8 "hoses with an inner diameter of 10 millimeters and an outer diameter of 12-13mm.
The thread is G1 / 4 and is therefore suitable for most water blocks, reservoirs and etc.
Thanks to the 90 degree angle, you can also place a water block in hard-to-reach places in your system, without kinks in your hoses!
You do not need a hose clamp with these fittings.
You slide your hose over the fitting and screw the hose to the fitting using the supplied "bolt".
The fitting also features an O-ring for a watertight seal.
Material: Black nickel plated brass, rubber O-ring
For 3/8 "ID - 1/2" OD hoses
G1 / 4 "Thread with rotating shaft
Thread length: 5mm