Worldwide shipping with GLS, DPD, PostNL & UPS! We ship to every country, your country not listed? Contact us

Mayhems Blitz Kit

 -   - 
Our price: 27,95 (23,10 excl tax)
Price in points: 116 points
Reward points: 2 points
+
Add to wish list

Mayhems Blitz Kit is the most comprehensive cleaning kit ever released for liquid cooling computers. It has been developed to clean you radiator’s better than new and leave your system in perfect condition.

Even though this is a cleaning solution it is not a long term effective inhibitor. Never leave it in your system longer than 24 hours.

This cleaning system is not safe to use around children and animals. Part 1 and Part 2 of the system uses highly effective cleaning acids down to PH 2 and you must take appropriate measures when using such products. You can dispose of the fluids down the drain once they have been diluted.

Contents
· 250ml Mayhems Blitz Part 1, 250ml (will dilute to 1 Ltrs of fluid)
· 100ml Mayhems Blitz Part 2, 100ml (will dilute to 4 Ltrs of fluid)
· Rubber Gloves 4 sets
· Safety Goggles 
· Instructions
· Warning Sheet

For internal use on Copper / Brass radiators only.
Do not use on plated products.
Do not spill on paint work and if you do so, rinse off immediately.

· Maximum effectiveness
· Rapid neutralisation of surface rust, contamination and oxidation
· Rigorous removal of mineral scale deposits
· Excellent suspension of particulates
· Low foaming
· Hard water tolerant
· Can be disposed of down grey-water (waste / outside) drain
· With "Care" this is easy to handle and straight forward to use
· May Improve heat transfer rate

Usage of Part 1 of the Mayhems Blitz Cleaning System

1. Put on the Gloves provided in the kit.
2. Mix Part one with deionised water / distilled water (either will do) to a ratio of 250ml of part 1 to 750ml of water.
3. Add to the radiator and clean up any spills immediately.
4. Vent the system of any trapped air and cap the radiator.
5. Leave in Radiator between 6 to 12 hours.
6. After empty down the waste drain. Refill with deionised water / distilled water (either will do) and rise out.
7. Repeat step 6 two times.
8. Refit to loop and move to Part 2 of the cleaning system.

· pH neutral (Ph7 -0.5 / +0.5)
· Effective neutralisation of contaminants.
· Good removal of slime, silt & detritus
· Excellent suspension of particulates
· Hard water tolerant
· Can be disposed of down grey-water (waste / outside) drain
· May Improve heat transfer rate

Usage of Part 2 Mayhems Blitz Cleaning System

1. Drain existing system contents.
2. Mix Part two with deionised water / distilled water (either will do) to a ratio of 25ml of Mayhems Blitz part 2 to 975ml of water.
3. Mayhems Blitz Part 2 will create a lot of foam. Please add to system slowly, do not over fill.
4. Vent the system of any trapped air. Do this by tilting the pc to release any tapped air from the radiator.
5. Check for leaks. Using just the pump, recirculate the fluids for 24 hours continuously. Regularly check any installed filters and clean as necessary.
6. Refill with deionised water / distilled water (either will do).
7. Run for 30 minutes
8. Empty out and refill with deionised water / distilled water (either will do)
9. Run for 30 minutes
10. Empty out and fill with your favourite coolant.

WARNING

This cleaning system is not safe to use around children and animals. Part 1 and Part 2 of the system uses highly effective cleaning acids down to PH 2 and you must take appropriate measures when using such products. You can dispose of the fluids down the drain once they have been diluted.

Manufacturer:
Mayhems

As usual radiators are not clean enough from the factory. So before installing them in to your liquid cooling loop it is important to clean them from production leftover particles, solder flux and other debris. This kit does exaclty this and in my opinion alot better than traditional solutions like hot water and white vinegar.

But this is only one part of the kit. The other part is meant to clean all other components of your loop (tubes, blocks, reservoir and fittings) and prepare the loop for the actual cooling liquid. Been using this kit for my PC's annually and until now all of them are free of residues and other liquid related issues.

Write a review

Customers also bought

 -   - 
2,50 (2,07 excl tax)
 - 
2,50 (2,07 excl tax)
 -   - 
7,95 (6,57 excl tax)
1,00 (0,83 excl tax)
 - 
1,95 (1,61 excl tax)
3,50 (2,89 excl tax)
 -   - 
3,00 (2,48 excl tax)
 -   - 
4,05 (3,35 excl tax)
 -   - 
2,50 (2,07 excl tax)
 -   - 
6,95 (5,74 excl tax)
0,50 (0,41 excl tax)
1,00 (0,83 excl tax)
 -   - 
8,95 (7,40 excl tax)
 - 
24,95 (20,62 excl tax)