Owners of Phanteks ENTHOO EVOLV X GLASS cases, Bitspower has you covered for your water reservoir and pump needs with the Bitspower Touchaqua Sedna PH518. While being a perfect fit within this mid-tower chassis, the reservoir’s PWM enabled S1 pump is dissimulated at the back in order to provide an unaltered look to your PC.
With novice modders in mind, Bitspower designed a reservoir that is easy to install while providing a professional look. Equipped with multiple water inlets and outlets to route the water from the radiator to the VGA than the CPU, this reservoirs also gives you more playroom for the graphics card location with a dual inlet/outlet designed to prevent having to bend more tubes and create a cleaner look to your loop.
The Bitspower Touchaqua Sedna PH518, equipped with Bitspower Digital RGB, is sure to become the center of attention of your case with bright LEDs that are certified by ASUS AURA Sync, GIGABYTE RGB Fusion, MSI Mystic Light Sync, and ASRock Polychrome.
LED Color : Digital RGB
LED Strip Management By Bitspower Digital RGB And Certified By ASUS AURA Sync, GIGABYTE RGB Fusion, MSI Mystic Light Sync, ASRock Polychrome and Razer Chroma
Phanteks ENTHOO EVOLV X GLASS
1set of BPTA-WDPPH518-R-PWM
1pcs of BPTA-EFW-V2-GS
1pcs of BPTA-EXAIR-GS
1pcs of Bracket
1set of Mounting Screws
S1 Pump Spec.
Rated voltage：12V DC
Maximum system temperature：60℃
Electric Connector：Molex 4 Pin
Dimension(LxWxH) : 370x180x53 MM
I wanna show off, but what's the support I'd need?
The end of power supply is 3PIN. The sequence is +/D/↓ (some motherboards are shown +5V/D/↓, and the plug is like 4PIN but the 3rd PIN is empty). Please plug in the corresponding direction of motherboard, controller or the wire integrator for one to many. If choosing the motherboard as the power supply, the light effect can be synchronize with MB.
*** Bitspower reserves the right to change the product design and interpretations. These are subject to change without notice. Product colors and accessories are based on the actual product. ***
*** From 15th March 2018, all of our installation guides will be provided electronically via an easy-to-use QR code attached to the packaging. ***
*** Before filling in the water, please make sure all the components are installed correctly. To prevent any leakage which may damage the PC components, please perform a 24-hour leaking test with only the pump connected to the power supply. ***
Last updated : 2019-08-27 15:20:04