Order in time! HighFlow is going on a two week holiday, from April 21 to May 9 2023! *INFO*

WORLDWIDE SHIPPING with GLS, DPD, PostNL & UPS. We ship to every country! Your country not listed? Please contact us.

Swiftech MCP35X Reservoir with 2 inlet ports Rev.2b

 -   - 
List price: 30,95   ( 25,58   excl tax)
Our price:  19,95  (16,49  excl tax)
You save: 11,00 (36%) (9,09 excl tax)
Price in points: 83 points
Reward points: 2 points

Swiftech MCP35X Reservoir with 2 inlet ports

Designed specifically for the MCP35X pump, this optional reservoir features 2 inlet ports for parallel loop splitting, and 6 different body orientations for convenient tube routing; the reservoir can be rotated to align the inlet ports at 12 o'clock, 2, 4, 6, 8, and 10 o'clock.

Compression fittings up to 1/2" (tube OD) are currently supported.

Including (1) plug, no fittings

If you do not have a MCP35X pump, the MCP35XH top/housing is needed to fit this reservoir onto your DDC pump (see related products).

Forgot an important point: This reservoir has 8 small holes in the bottom. The original top has 1 matching hole facing forward. By using a small included metal pin/rod you can orient and fasten the reservoir to face a certain way. In order to make sure it face a certain way, you NEED the original Swiftech top though. You can use this reservoir with other tops, just make sure they are FLAT and EVEN, so no grooves or anything as it depends on a flat surface and an O-ring to make it watertight. You will also need a long, broad flat-headed screwdriver (or a metal ruler in my case) to fasten the reservoir to the top.
  I would like to give it 5 stars, but I can't as the black spunge are whirled up into the reservoir if you use one of the 2 side ports. The black spunge also floats to the top when your pump is turned off, and it does not get sucked back down even with very powerfull swiftech mcp 35x pump Only way to keep it down is to make/buy an inner tube that physically holds it down. All of the above also makes it hard to bleed (get the air out), as the reservoir instead churn air into the loop!! If you use the top port as inlet it is hard to fill in water as needed, but if you use the top port as inlet AND make an inner tube straight down, to hold the spunge down, you get the BEST performance of almost any reservoirs AND it bleeds very very fast.. so 4 stars even though it has some major issues.
Heb gemerkt dat als je dit reservoir niet op de MCP35X pomp heb, de pomp gewoonweg niet optimaal functioneerd. Het heeft de druk nodig van de vloeistof in het reservoir. Simpel en doeltreffend zijn de spons en het gaasje waardoor er geen luchtbellen in de loop komen.
Write a review
As soon as the price of the products decreases, you will immediately know about it:
Keep track of price reductions

The price has not changed yet. We will show it on this chart once it changes