WORLDWIDE SHIPPING with GLS, DPD, PostNL & UPS. We ship to every country! Your country not listed? Please contact us.

10MM (3/8 ID - 1/2 OD) Compression Fitting 90 degrees - G1/4 Black Nickel

 -   - 
Our price:  5,95  (4,92  excl tax)
Price in points: 25 points

10MM (3/8 ID - 1/2 OD) Screw fitting 90 degrees - G1 / 4 Black Nickel

90 degree angle Screw fitting for 3/8 "hoses with an inner diameter of 10 millimeters and an outer diameter of 12-13mm.

The thread is G1 / 4 and is therefore suitable for most water blocks, reservoirs and etc.

Thanks to the 90 degree angle, you can also place a water block in hard-to-reach places in your system, without kinks in your hoses!

You do not need a hose clamp with these fittings.
You slide your hose over the fitting and screw the hose to the fitting using the supplied "bolt".

The fitting also features an O-ring for a watertight seal.

Material: Black nickel plated brass, rubber O-ring
For 3/8 "ID - 1/2" OD hoses
G1 / 4 "Thread with rotating shaft
Height: 23mm
Thread length: 5mm
Diameter: 19mm

A Brand
Matige fitting. Hij is niet zo mooi als duurdere fittingen. had er 2 besteld en had bij eentje een lekkage. Ook kan je hem 360 graden draaien maar dit gaat erg stroef dat probleem had ik niet bij duurdere 90 graden fittingen. Hij sluit verder wel prima aan op de slang.
Heb deze een tijd terug besteld. de dag erna gelijk al in de busdus ik zeg: SuperOok moest ik wel lachen om het snoepje wat ik bij mijn bestelling kreeg !Ik haal vanaf nu altijd mijn waterkoel spullen hier !
Write a review
As soon as the price of the products decreases, you will immediately know about it.
Keep track of price reductions

The price has not changed yet. We will show it on this chart once it changes